No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

AR500, AR510, and AR530 V200R007 CLI-based Configuration Guide - Ethernet Switching

This document describes the configuration of Ethernet services, including configuring transparent bridge, MAC table, link aggregation, VLANs, STP/RSTP/MSTP, and so on.The document provides the configuration procedures and configuration examples to illustrate the service configuration methods and application scenario.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Configuring the Mode in Which Ports Are Added to a Voice VLAN

Configuring the Mode in Which Ports Are Added to a Voice VLAN

Procedure

  1. Run:

    system-view

    The system view is displayed.

  2. Run:

    interface interface-type interface-number

    The interface view is displayed.

  3. Run:

    voice-vlan mode manual

    The mode in which ports are added to a voice VLAN is set to manual.

    By default, ports are automatically added to a voice VLAN.

  4. Add ports to a voice VLAN.
    • If access ports are connected to voice devices, run the port default vlan vlan-id command to manually add these ports to a voice VLAN.
    • If trunk ports are connected to voice devices, run the port trunk allow-pass vlan vlan-id command to manually add these ports to a voice VLAN.
    • If hybrid ports are connected to voice devices, do as follows as required:

      • Run the port hybrid untagged vlan vlan-id command to manually add these ports to a voice VLAN in untagged mode.

        NOTE:
        Only the 8FE1GE and 24GE cards support untagged packets.
      • Run the port hybrid tagged vlan vlan-id command to manually add these ports to a voice VLAN in tagged mode.

Translation
Download
Updated: 2019-05-25

Document ID: EDOC1000097279

Views: 16751

Downloads: 63

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next