No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

AR500, AR510, and AR530 V200R007 CLI-based Configuration Guide - Ethernet Switching

This document describes the configuration of Ethernet services, including configuring transparent bridge, MAC table, link aggregation, VLANs, STP/RSTP/MSTP, and so on.The document provides the configuration procedures and configuration examples to illustrate the service configuration methods and application scenario.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
(Optional) Configuring a Load Balancing Mode

(Optional) Configuring a Load Balancing Mode

Context

Perform the following steps on the device to configure a load balancing mode for an Eth-Trunk.

NOTE:

The AR500 series do not support the load balancing mode configuration.

The 8ES2G and 8ES2GS cards do not support the load balancing mode configuration.

Procedure

  • Configure a Layer 2 Eth-Trunk.
    1. Run:

      system-view

      The system view is displayed.

    2. Run:

      load-balance { dst-ip | dst-mac | src-ip | src-mac | src-dst-ip | src-dst-mac }

      A load balancing mode is configured for the Eth-Trunk.

      By default, the load balancing mode of a Layer 2 Eth-Trunk is src-dst-mac.

      Eth-Trunk member interfaces use flow-based load balancing. The local and remote ends can use different load balancing modes, without affecting each other.

      NOTE:

      All Layer 2 Eth-Trunks in the system must use the same load balancing mode. If the load balancing mode of one Eth-Trunk is changed, all the other Eth-Trunks use the new load balancing mode.

  • Configure a Layer 3 Eth-Trunk.
    1. Run:

      system-view

      The system view is displayed.

    2. Run:

      interface eth-trunk trunk-id

      The Eth-Trunk interface view is displayed.

    3. Run:

      load-balance { dst-ip | dst-mac | src-ip | src-mac | src-dst-ip | src-dst-mac }

      A load balancing mode is configured for the Eth-Trunk.

      By default, the load balancing mode of a Layer 3 Eth-Trunk is src-dst-ip.

      Eth-Trunk member interfaces use flow-based load balancing. The local and remote ends can use different load balancing modes, without affecting each other.

Translation
Download
Updated: 2019-05-25

Document ID: EDOC1000097279

Views: 20397

Downloads: 64

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next