No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

AR500, AR510, and AR530 V200R007 CLI-based Configuration Guide - Ethernet Switching

This document describes the configuration of Ethernet services, including configuring transparent bridge, MAC table, link aggregation, VLANs, STP/RSTP/MSTP, and so on.The document provides the configuration procedures and configuration examples to illustrate the service configuration methods and application scenario.
Rate and give feedback :
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
(Optional) Setting the LACP Interface Priority

(Optional) Setting the LACP Interface Priority

Context

In LACP mode, LACP interface priorities are set to prioritize interfaces of the same device. Interfaces with higher priorities are selected as active interfaces.

Procedure

  1. Run:

    system-view

    The system view is displayed.

  2. Run:

    interface interface-type interface-number

    The member interface view is displayed.

  3. Run:

    lacp priority priority

    The LACP priority of the member interface is configured.

    By default, the LACP interface priority is 32768. A smaller priority value indicates a higher LACP priority.

    By default, the system selects active interfaces based on interface priorities. However, low-speed member interfaces with high priorities may be selected as active interfaces. To select high-speed member interfaces as active interfaces, run the lacp selected { priority | speed } command to configure the system to select active interfaces based on the interface rate.

Translation
Download
Updated: 2019-05-25

Document ID: EDOC1000097279

Views: 11572

Downloads: 62

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next