No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

AR500, AR510, and AR530 V200R007 CLI-based Configuration Guide - Ethernet Switching

This document describes the configuration of Ethernet services, including configuring transparent bridge, MAC table, link aggregation, VLANs, STP/RSTP/MSTP, and so on.The document provides the configuration procedures and configuration examples to illustrate the service configuration methods and application scenario.
Rate and give feedback :
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Enabling IP Routing for a Bridge Group

Enabling IP Routing for a Bridge Group

Context

IP routing enables a bridge group to bridge and route packets. If IP routing is not enabled, all protocol packets can only be bridged. After IP routing is enabled, specified protocol packets can be bridged or routed depending on the configuration.

Procedure

  1. Run:

    system-view

    The system view is displayed.

  2. Run:

    bridge bridge-id

    The bridge group view is displayed.

  3. Run:

    routing ip

    IP routing is enabled for the bridge group.

    The IP routing function cannot be configured if any of member interfaces in the bridge group has an IP address. Before configuring the IP routing function, delete the IP addresses of these member interfaces.

  4. Run:

    quit

    Return to the system view.

  5. Run:

    interface bridge-if bridge-id

    A Bridge-if interface is created and the Bridge-if interface view is displayed.

  6. Run:

    ip address ip-address { mask | mask-length }

    An IP address is configured for the Bridge-if interface.

  7. (Optional) Run:

    mac-address mac-address

    A MAC address is configured for the Bridge-if interface.

Translation
Download
Updated: 2019-05-25

Document ID: EDOC1000097279

Views: 8287

Downloads: 62

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next