No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search


To have a better experience, please upgrade your IE browser.


AR500, AR510, and AR530 V200R007 CLI-based Configuration Guide - Ethernet Switching

This document describes the configuration of Ethernet services, including configuring transparent bridge, MAC table, link aggregation, VLANs, STP/RSTP/MSTP, and so on.The document provides the configuration procedures and configuration examples to illustrate the service configuration methods and application scenario.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Configuring a VLANIF Interface Corresponding to a Super-VLAN

Configuring a VLANIF Interface Corresponding to a Super-VLAN


The IP address of the VLANIF interface corresponding to a super-VLAN must contain the subnets that users in sub-VLANs belong to. All the sub-VLANs use the IP address of the VLANIF interface corresponding to the super-VLAN, thereby saving IP addresses.


  1. Run:


    The system view is displayed.

  2. Run:

    interface vlanif vlan-id

    A VLANIF interface is created for a super-VLAN, and the view of the VLANIF interface is displayed.

  3. Run:

    ip address ip-address { mask | mask-length }

    An IP address is assigned to the VLANIF interface.

Updated: 2019-05-25

Document ID: EDOC1000097279

Views: 20183

Downloads: 64

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Previous Next