No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

CLI-based Configuration Guide - IP Multicast

AR500, AR510, and AR530 V200R007

This document describes the principles and configurations of IP multicast, and provides configuration examples.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Default Configuration

Default Configuration

Table 5-2 lists the default IPv6 PIM configuration.

Table 5-2  Default IPv6 PIM configuration
Parameter Default Setting

IPv6 Multicast routing

Disabled

IPv6 PIM-DM

Disabled

State refresh

Enabled after IPv6 PIM-DM is enabled

IPv6 PIM-SM

Disabled

Static RP address

Unspecified

C-RP interface

Unspecified

C-BSR interface

Unspecified

Embedded RP

Enabled after IPv6 PIM-SM is enabled (The industrial switch router can parse IPv6 multicast addresses in the range of FF7x::/12, in which x can be 0 or any value ranging from 3 to F.)

DR priority

1

SPT switchover conditions

First multicast packet received by the RP or the DR at the member side

Range of IPv6 SSM group addresses

FF3x::/32 (x is not 1 or 2)

IPv6 PIM silent

Disabled

Translation
Download
Updated: 2019-06-12

Document ID: EDOC1000097280

Views: 9931

Downloads: 20

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next