No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

CLI-based Configuration Guide - IP Multicast

AR500, AR510, and AR530 V200R007

This document describes the principles and configurations of IP multicast, and provides configuration examples.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Configuring IGMP Fast Leave

Configuring IGMP Fast Leave

Context

In some scenarios (ADSL dial-up for example), a querier interface connects to only one receiver host. If the host frequently switches between multiple multicast groups (for example, it switches TV channels frequently), you can configure the fast leave function on the interface so that the interface can quickly respond to Leave messages sent from the host.

After the fast leave function is configured, the querier does not send a Group-Specific Query message after receiving a Leave message from the host. Instead, the querier directly notifies the upstream multicast device that the host has left the multicast group. The fast leave function reduces delay in response to Leave messages and saves network bandwidth.

IGMP fast leave applies only to IGMPv2 and IGMPv3.

Procedure

  1. Run:

    system-view

    The system view is displayed.

  2. Run:

    interface interface-type interface-number

    The interface view is displayed.

  3. Run:

    igmp prompt-leave [ group-policy { acl-number | acl-name acl-name } ]

    Fast leave is configured on the interface.

    By default, the industrial switch router sends a Group-Specific Query message after receiving a Leave message.

    NOTE:

    When configuring an ACL rule for an interface, use the permit parameter to allow the hosts connected to the interface to quickly leave multicast groups with addresses in a specified range. If no rule is configured in the ACL, the hosts connected to the interface cannot fast leave any multicast groups.

Translation
Download
Updated: 2019-06-12

Document ID: EDOC1000097280

Views: 10078

Downloads: 21

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next