No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

CLI-based Configuration Guide - IP Multicast

AR500, AR510, and AR530 V200R007

This document describes the principles and configurations of IP multicast, and provides configuration examples.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Using MPing to Check Multicast Service Performance

Using MPing to Check Multicast Service Performance

Context

Multicast devices need to support not only multicast forwarding and multicast routing protocols but also multicast diagnostic tools.

Multicast ping (MPing) is a diagnostic tool that can be used to:

  • Ping a common group address.
  • Check the multicast routing table on the industrial switch router to determine the protocol operating status and the establishment of the multicast distribution tree.
  • Collect statistics on received Internet Control Message Protocol (ICMP) Echo Reply packets from the destination host and calculate the TTL and response time from the ping initiator to the group member.
  • Calculate the network delay and route jitter by performing MPing tests continuously.
  • Ping a reserved group address to check reserved group members on the network.

Procedure

  1. Run the ping multicast [ -c count | -h ttl-value | -i interface-type interface-number | -m time | -p pattern | -q | -s packetsize | -t timeout | -tos tos-value | -v ] * host command to monitor multicast service performance.

    B specifying a reserved group address as the destination address in the command, you can check whether the router's interface connected to the specified interface is running a multicast protocol and has joined the reserved group.

    NOTE:

    When the destination address is a reserved group address, you must specify the parameter -i. When the destination is not a reserved group address, you cannot specify the parameter -i.

Translation
Download
Updated: 2019-06-12

Document ID: EDOC1000097280

Views: 10965

Downloads: 21

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next