No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

CLI-based Configuration Guide - IP Multicast

AR500, AR510, and AR530 V200R007

This document describes the principles and configurations of IP multicast, and provides configuration examples.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Configuring the Source RP Address of the SA Message

Configuring the Source RP Address of the SA Message

Context

In the anycast RP application, you need to configure rendezvous points (RPs) on two or more devices in a Protocol Independent Multicast Sparse Mode (PIM-SM) domain, assign the same IP address to these RPs, and set up MSDP peer relationships between these devices. An MSDP peer performs the RPF check on a received SA message and then discards the message if the addresses of the local RP and the remote RP are the same. Therefore, you need to specify a logical RP address for the SA message on the device on which anycast RP is to be configured.

Procedure

  1. Run:

    system-view

    The system view is displayed.

  2. Run:

    msdp [ vpn-instance vpn-instance-name ]

    The MSDP view is displayed.

  3. Run:

    originating-rp interface-type interface-number

    The address of the logical RP interface is set as the source RP address for the SA message.

    The interface functioning as a logical RP cannot be an actual RP interface. It is recommended that you configure the address of the MSDP peer interface as the logical RP address.

Translation
Download
Updated: 2019-06-12

Document ID: EDOC1000097280

Views: 10833

Downloads: 21

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next