No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

CLI-based Configuration Guide - Security

AR500, AR510, and AR530 V200R007

This document describes the configurations of Security, including AAA, DAA,NAC, BRAS Access, ACL, Firewall, Deep Security Defense, Local Attack Defense;Attack Defense, Traffic Suppression, ARP Security, Port Security, DHCP Snooping, IPSG, URPF, PKI, SSL, HTTPS, Keychain, separating the management plane from the service plane, security risks.
Rate and give feedback :
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Configuring an Attack Source Tracing Mode

Configuring an Attack Source Tracing Mode

Context

After attack source tracing is enabled, you need to set a mode in which the device traces attack sources. The device supports the following attack source tracing modes:
  • Source IP address-based tracing: prevents Layer 3 attack packets.
  • Source MAC address-based tracing: prevents Layer 2 attack packets with a fixed source MAC address.
  • Tracing based on a combination of source port and VLAN: prevents Layer 2 attack packets with different source MAC addresses.

Procedure

  1. Run:

    system-view

    The system view is displayed.

  2. Run:

    cpu-defend policy policy-name

    The attack defense policy view is displayed.

  3. Run:

    auto-defend enable

    Attack source tracing is enabled.

    By default, attack source tracing is disabled.

  4. Run:

    auto-defend trace-type { source-ip | source-mac |  source-portvlan } * 

    The attack source tracing mode is specified.

    By default, the device traces attack sources based on source MAC addresses, source IP addresses, and a combination of source ports+VLANs.

Translation
Download
Updated: 2019-05-25

Document ID: EDOC1000097287

Views: 13290

Downloads: 40

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next