No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search


To have a better experience, please upgrade your IE browser.


CLI-based Configuration Guide - Security

AR500, AR510, and AR530 V200R007

This document describes the configurations of Security, including AAA, DAA,NAC, BRAS Access, ACL, Firewall, Deep Security Defense, Local Attack Defense;Attack Defense, Traffic Suppression, ARP Security, Port Security, DHCP Snooping, IPSG, URPF, PKI, SSL, HTTPS, Keychain, separating the management plane from the service plane, security risks.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Configuring an HSB Group

Configuring an HSB Group


An HSB group instructs service modules to perform batch backup, real-time backup, and status synchronization. The backup of services depends on the status negotiation and event notification mechanisms provided by the HSB group, synchronizing services on the master and backup devices.

An HSB group synchronizes backup information and responds to link status changes through the HSB channel established by the HSB service. To make the HSB group work properly, bind an HSB service to the HSB group. In addition, the HSB group must be bound to a VRRP group to negotiate the service status based on the VRRP status. By monitoring the changes in the bound channel status and VRRP status, the HSB group instructs service modules to perform batch backup, real-time backup, and status synchronization.


  1. Run:


    The system view is displayed.

  2. Run:

    hsb-group group-index

    An HSB group is created and the HSB group view is displayed.

  3. Run:

    bind-service service-index

    An HSB service is configured for binding to the HSB group.

  4. Run:

    track vrrp vrid vitual-router-id interface interface-type interface-number

    A VRRP group is configured for binding to the HSB group.

  5. Run:


    The system view is displayed.

Updated: 2019-05-25

Document ID: EDOC1000097287

Views: 13572

Downloads: 40

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Previous Next