No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search


To have a better experience, please upgrade your IE browser.


AR500, AR510, and AR530 V200R007 Commands Reference

This document describes all the configuration commands of the device, including the command function, syntax, parameters, views, default level, usage guidelines, examples, and related commands.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
display ipsec proposal

display ipsec proposal


The display ipsec proposal command displays IPSec proposal information.


display ipsec proposal [ name proposal-name ]






Specifies the name of an IPSec proposal. If the name of an IPSec proposal is not specified, information about all IPSec proposals is displayed.

The value is an existing IPSec proposal name.


All views

Default Level

1: Monitoring level

Usage Guidelines



# Display information about all IPSec proposals.

<Huawei> display ipsec proposal

Number of proposals: 1

IPsec proposal name: jiang
 Encapsulation mode: Tunnel
 Transform         : esp-new
 ESP protocol      : Authentication SHA2-HMAC-256
                     Encryption     AES-192
Table 10-34  Description of the display ipsec proposal command output



IPsec proposal name

Name of an IPSec proposal. To configure an IPSec proposal, run the ipsec proposal command.

Encapsulation mode

IPSec encapsulation mode:
  • Tunnel
  • Transport
To configure an encapsulation mode, run the encapsulation-mode command.


Security protocol:
  • ah-new: AH is used.
  • ah-esp-new: AH and ESP are used.
  • esp-new: ESP is used.
To configure a security protocol, run the transform command.

ESP protocol

Authentication algorithm and encryption algorithm used by the ESP protocol. To configure an authentication algorithm used by the ESP protocol, run the esp authentication-algorithm command. To configure an encryption algorithm used by the ESP protocol, run the esp encryption-algorithm command.

AH protocol

Authentication algorithm used by the AH protocol. To configure an authentication algorithm used by the AH protocol, run the ah authentication-algorithm command.

Updated: 2019-05-29

Document ID: EDOC1000097293

Views: 88828

Downloads: 121

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Previous Next