No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

AR500, AR510, and AR530 V200R007 Commands Reference

This document describes all the configuration commands of the device, including the command function, syntax, parameters, views, default level, usage guidelines, examples, and related commands.
Rate and give feedback :
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
lifetime-notification-message enable

lifetime-notification-message enable

Function

The lifetime-notification-message enable command enables the device to send IKE SA lifetime notification messages.

The undo lifetime-notification-message enable command disables the device from sending IKE SA lifetime notification messages.

By default, the device cannot send IKE SA lifetime notification messages.

Format

lifetime-notification-message enable

undo lifetime-notification-message enable

Parameters

None

Views

IKE peer view

Default Level

2: Configuration level

Usage Guidelines

Usage Scenario

You can run the sa duration (IKE proposal view) command to configure an IKE SA lifetime in an IKE proposal. If the IKE SA lifetimes of two ends are different, the two ends use the smaller IKE SA lifetime for IKE negotiation.

  • When a Huawei device (responder) wants to set up an IPSec tunnel with a Cisco systems VPN client (initiator) and the IKE SA lifetimes configured at two ends are different, you can run this command to enable the Huawei device to send IKE SA lifetime notification messages to the Cisco device to ensure successful IKE negotiation between them. If the Huawei device is disabled from sending IKE SA lifetime notification messages to the peer, the IKE negotiation fails.

  • You can also run this command when two Huawei devices want to set up an IPSec tunnel. However, the configuration takes effect on the responder only. If you cannot determine which end is the initiator, you are advised to configure this command on devices at both ends.

Precautions

This command is supported by IKEv1 only.

Example

# Enable the IKE peer named peer1 to send IKE SA lifetime notification messages.

<Huawei> system-view
[Huawei] ike peer peer1 v1
[Huawei-ike-peer-peer1] lifetime-notification-message enable
Translation
Download
Updated: 2019-05-29

Document ID: EDOC1000097293

Views: 48222

Downloads: 102

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next