No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search


To have a better experience, please upgrade your IE browser.


AR500, AR510, and AR530 V200R007 Commands Reference

This document describes all the configuration commands of the device, including the command function, syntax, parameters, views, default level, usage guidelines, examples, and related commands.

Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
tunnel remote

tunnel remote


The tunnel remote command configures an IP address for the remote end of an IPSec tunnel.

The undo tunnel remote command cancels the configuration.

By default, the remote end of an IPSec tunnel is not configured with an IP address.


tunnel remote ip-address

undo tunnel remote






Specifies the IP address of the remote end on an IPSec tunnel.

A valid IPv4 address in dotted decimal notation.


Manual IPSec policy view

Default Level

2: Configuration level

Usage Guidelines

Usage Scenario

The tunnel remote command configures an IP address for the remote end of an IPSec tunnel.

If an IPSec policy is created manually, you must run the tunnel remote ip-address command so that an SA can be created. An IPSec tunnel can be set up successfully only when the local and remote addresses are correctly configured.


If an IPSec policy is created manually, the tunnel remote at the local end must be the same as the local IP tunnel local at the remote end.


# Configure the IP address for the remote end of the IPSec tunnel to

<Huawei> system-view
[Huawei] ipsec policy policy1 100 manual
[Huawei-ipsec-policy-manual-policy1-100] tunnel remote
Updated: 2019-05-29

Document ID: EDOC1000097293

Views: 146565

Downloads: 157

Average rating:
This Document Applies to these Products

Related Version

Related Documents

Previous Next