No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search


To have a better experience, please upgrade your IE browser.


AR500, AR510, and AR530 V200R007 Commands Reference

This document describes all the configuration commands of the device, including the command function, syntax, parameters, views, default level, usage guidelines, examples, and related commands.

Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
display telnet-client

display telnet-client


The display telnet-client command displays the source parameters when the device works as a Telnet client.


display telnet-client




All views

Default Level

3: Management level

Usage Guidelines

After setting source parameters of the Telnet client, you can run this command to check the setting result. If you have not set telnet client-source, the default source IP address is


# Display the source parameters for the device that works as a Telnet client.

<Huawei> display telnet-client
 The source address of telnet client is
Table 2-32  Description of the display telnet-client command output



The source address of telnet client is

The source IP address of the Telnet client is

Updated: 2019-05-29

Document ID: EDOC1000097293

Views: 137258

Downloads: 148

Average rating:
This Document Applies to these Products

Related Version

Related Documents

Previous Next