No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search


To have a better experience, please upgrade your IE browser.


AR500, AR510, and AR530 V200R007 Commands Reference

This document describes all the configuration commands of the device, including the command function, syntax, parameters, views, default level, usage guidelines, examples, and related commands.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).



The super command switches a user from the current level to a specified level.


super [ level ]


Parameter Description Value
level Specifies the target user level. The value is an integer that ranges from 0 to 15. By default, a user is switched to level 3.


User view

Default Level

0: Visit level

Usage Guidelines

Usage Scenario

Users are assigned one of 16 levels, and these levels correspond to command levels. After logging in to the device, users can use only the commands whose levels are equal to or lower than their user levels.

When a user is switched from a lower level to a higher level, the device requires the user to enter the authentication password for the higher user level to authenticate the user identity, preventing unauthorized users from logging in to the device. You can run the super password command to set an authentication password used to switch a user from a lower level to a higher level.

If the entered target user level is lower than or equal to the current user level, the system directly sets the entered user level as the target user level, and displays a message. If the target level is higher than the current user level, the system asks the user to enter the authentication password.

The password entered by a user is not displayed on the screen. If the user enters the correct password within three times, the system switches the user to the higher user level; otherwise, the user level remains unchanged.


  • The configured target level takes effect only for the current user. The user level restores to the original level the next time the user logs in.
  • The password is a string of 8 to 16 characters.

  • The password must be a combination of at least two of the following: uppercase letters A to Z, lowercase letters a to z, digits, and special characters.

    Special characters include ` ~ ! @ # $ % ^ & * ( ) - _ = + \ | [ { } ] ; : ' " , < . > / ? spaces.

  • The password must be the same as the password set using the super password command.


# Switch a user to level 10.

<Huawei> super 10
  Now user privilege is level 10, and only those commands whose level is        
  equal to or less than this level can be used.                                 
  Privilege note: 0-VISIT, 1-MONITOR, 2-SYSTEM, 3-MANAGE
Related Topics
Updated: 2019-05-29

Document ID: EDOC1000097293

Views: 88827

Downloads: 121

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Previous Next