No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search


To have a better experience, please upgrade your IE browser.


AR500, AR510, and AR530 V200R007 Commands Reference

This document describes all the configuration commands of the device, including the command function, syntax, parameters, views, default level, usage guidelines, examples, and related commands.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
restart (interface view)

restart (interface view)


The restart command restarts an interface.






Interface view

Default Level

2: Configuration level

Usage Guidelines

Usage Scenario

After modifying parameters of an interface, run the restart command to make the modification take effect.


  • Restarting an interface during data transmission will cause data frame loss or service interruption. Exercise caution when you use the restart command.

  • Running the restart command is equivalent to running the shutdown command and the undo shutdown command in sequence.


# Restart Eth0/0/1.

<Huawei> system-view
[Huawei] interface ethernet 0/0/1
[Huawei-Ethernet0/0/1] restart
Updated: 2019-05-29

Document ID: EDOC1000097293

Views: 90873

Downloads: 124

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Previous Next