No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search


To have a better experience, please upgrade your IE browser.


AR500, AR510, and AR530 V200R007 Commands Reference

This document describes all the configuration commands of the device, including the command function, syntax, parameters, views, default level, usage guidelines, examples, and related commands.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
display ike global config

display ike global config


The display ike global config command displays the global IKE configuration.


display ike global config




All views

Default Level

1: Monitoring level

Usage Guidelines



# Display the global IKE configuration.

<Huawei> display ike global config
IKE Global Config:                                   
  IKE local-name                   : huawei
  IKE heartbeat-timer interval     : 30
  IKE heartbeat-timer timeout      : 100
  IKE nat-keepalive-timer interval : 52
  IKE certificate check crl        : disable
Table 10-13  Description of the display ike global config command output



IKE local-name

Local name used in IKE negotiation. To set the local name used in IKE negotiation, run the ike local-name command. If ike local-name is not configured on the local end, the name specified by the sysname command is used for IKE negotiation.

IKE heartbeat-timer interval

Interval at which an IKE SA sends a heartbeat packet, in seconds. To set the interval at which an IKE SA sends a heartbeat packet, run the ike heartbeat-timer interval command.

IKE heartbeat-timer timeout

Timeout interval of heartbeat packets, in seconds. To set the timeout interval of heartbeat packets, run the ike heartbeat-timer timeout command.

IKE nat-keepalive-timer interval

Interval at which an IKE SA sends a NAT keepalive packet, in seconds. To set the interval at which an IKE SA sends a NAT keepalive packet, run the ike nat-keepalive-timer interval command.

IKE certificate check crl

Whether CRL check is enabled when IKE uses a digital certificate for authentication. To enable CRL check, run the ike authentication certificate-check crl enable command.

Updated: 2019-05-29

Document ID: EDOC1000097293

Views: 89779

Downloads: 122

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Previous Next