No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Command Reference

AR500, AR510, and AR530 V200R007

This document describes all the configuration commands of the device, including the command function, syntax, parameters, views, default level, usage guidelines, examples, and related commands.
Rate and give feedback :
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
ip address

ip address

Function

The ip address command specifies the IP address of an allowed peer for IKE negotiation.

The undo ip address command deletes the IP address of an allowed peer.

By default, no IP address of allowed peer for IKE negotiation is configured.

Format

ip address ip-address { mask | mask-length }

undo ip address ip-address { mask | mask-length }

Parameters

Parameter

Description

Value

ip-address { mask | mask-length }

Specifies the IP address of an allowed peer.

  • ip-address specifies the IP address.
  • mask specifies the mask of the IP address.
  • mask-length specifies the mask length of IP address.
  • The value of ip-address is in dotted decimal notation.
  • The value of mask is in dotted decimal notation.
  • The value of mask-length is an integer that ranges from 0 to 32.

Views

Identity filter set view

Default Level

2: Configuration level

Usage Guidelines

Usage Scenario

You can run this command to specify an allowed peer based on the IP address (configured on a remote device for establishing an IPSec tunnel) in the identity filter set for IKE negotiation.

Precautions

An IPSec tunnel can be established only when the remote end matches one or more parameters in the identity filter set and the IPSec negotiation parameters at both ends are consistent.

If you run this command in the same view multiple times, the latest configuration does not override earlier ones.

Example

# Configure an IKE peer named huawei.

<Huawei> system-view
[Huawei] ike identity identity1
[Huawei-ike-identity-identity1] ip address 60.1.1.1 24
Translation
Download
Updated: 2019-02-18

Document ID: EDOC1000097293

Views: 36123

Downloads: 101

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next