No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

AR500, AR510, and AR530 V200R007 Commands Reference

This document describes all the configuration commands of the device, including the command function, syntax, parameters, views, default level, usage guidelines, examples, and related commands.
Rate and give feedback :
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
interface tunnel-template

interface tunnel-template

Function

The interface tunnel-template command creates a tunnel template interface and enters the tunnel template interface view.

The undo interface tunnel-template command deletes the tunnel template interface.

By default, no tunnel template interface exists.

Format

interface tunnel-template interface-number

undo interface tunnel-template interface-number

Parameters

Parameter

Description

Value

interface-number

Specifies the number of the tunnel template interface.

The value range depends on the device.

Views

System view

Default Level

2: Configuration level

Usage Guidelines

Usage Scenario

A virtual tunnel template interface is similar to a virtual tunnel interface. You can create a tunnel template interface on the headquarters gateway and then apply an IPSec profile to the tunnel template interface and the tunnel interface of the branch gateway respectively to enable the gateways to send or accept subnet route information.

Follow-up Procedure

After creating a tunnel template interface, run the tunnel-protocol ipsec command to set the encapsulation mode of the tunnel template interface to IPSec.

Example

# Create a tunnel template interface.

<Huawei> system-view
[Huawei] interface tunnel-template 1
[Huawei-Tunnel-Template1]
Translation
Download
Updated: 2019-05-29

Document ID: EDOC1000097293

Views: 52226

Downloads: 102

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next