No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search


To have a better experience, please upgrade your IE browser.


ES3000 V3 NVMe PCIe SSD User Guide 20

This document provides the product information about the Huawei ES3000 V3 PCIe SSD (ES3000 V3 for short) and describes how to install, configure, operate, and maintain the ES3000 V3.
Rate and give feedback :
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Transferring Files by Using WinSCP

Transferring Files by Using WinSCP

This section describes how to transfer files by using WinSCP. You can also transfer files by using other software.


Use WinSCP to transfer files from a PC to a remote host.



The File Transfer Protocol (FTP) service has been enabled on the remote host.


You have obtained the following data:
  • IP address of the remote host to be connected
  • User name and password for logging in to the remote host to be connected


WinSCP.exe: a free software available on the Internet.


  1. Open the WinSCP folder, and double-click WinSCP.exe.

    The WinSCP Login dialog box is displayed, as shown in Figure 3-9.


    To change the UI language, click Languages.

    Figure 3-9  WinSCP login

  2. Set the login parameters.

    The parameters are described as follows:
    • Host name: Enter the IP address of the remote host to be connected. For example,
    • Port number: The default value is 22.
    • User name: Enter the user name. For example, admin.
    • Password: Enter the password.

  3. Click Login.

    The WinSCP file transfer window is displayed.

    • If a key file was not selected during the first login, a warning Continue connecting and add host key to cache is displayed. Click Yes. The WinSCP file transfer page is displayed.
    • By default, the C:\Documents and Settings\Administrator\My Documents directory of the local PC is opened in the left pane, and the /root directory of the remote host is opened in the right pane.

  4. In the right pane, choose a directory of the remote host for storing files, for example, /root/firmware.
  5. In the left pane, select a directory of the local PC for storing files, for example E:\Software, and then select the file to be transferred.
  6. Choose File > Copy.

    The Copy dialog box is displayed.

  7. Confirm the file to be copied and the directory of the remote host, and then click Copy.

    The system starts to copy the file from the local PC to the remote host.

Updated: 2019-03-12

Document ID: EDOC1000101091

Views: 58898

Downloads: 1240

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Previous Next