No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

OceanStor 9000 V300R005C00 File System Feature Guide 11

Rate and give feedback :
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Discovering Storage Devices

Discovering Storage Devices

You can configure the management IP address, user name, and password for an OceanStor 9000 cluster to add the cluster to eSight.

Prerequisites

  • eSight can communicate with the management network of the OceanStor 9000 cluster through a route (eSight and the cluster can ping each other).

    If the OceanStor 9000 cluster has C72 nodes, eSight must reside on the same subnet as the management network of the OceanStor 9000 cluster and Layer 2 interconnection is required.

  • You have obtained the management IP address, user name, and password of an OceanStor 9000 cluster.

Procedure

  1. In the main menu, choose Resource > Add Resource > Add Resource.
  2. Choose Massive Storage.
  3. In the Basic Information area, enter the management IP address of the OceanStor 9000 cluster. In the Model area, select OceanStor 9000. In theVersion area, select V300R005.
  4. In the SNMP area, enter SNMP parameters for interconnecting with the OceanStor 9000 cluster.

    Figure 11-2shows parameters for interconnection.

    Figure 11-2  SNMP interconnection

    Set Type to SNMPv3, Port to 161, Attempts and Timeout to 3, and Context Name to Array. The settings of Username, Authentication protocol, Authentication password, and Privacy protocol, and Privacy password must be consistent with the settings configured for the OceanStor 9000 in Configuring Storage Devices.

  5. Click OK.

    NOTE:

    If discovering storage devices fails, restart the eSight.

Follow-up Procedure

Protocol parameters are used for communications between the network management system (NMS) and network elements (NEs). If protocol parameters at the NE side are changed, modify also the protocol parameters at the NMS side.
  1. On the menu bar, choose Resource > Resource Management > Storage Device.
  2. In the navigation tree, choose Massive Storage.
  3. In the function pane, click the name of the OceanStor 9000.
  4. In the navigation tree, choose Configuration > Protocol Parameter.
  5. Set the protocol parameters and click Test.
  6. After the test succeeds, click Apply.
Translation
Download
Updated: 2019-03-30

Document ID: EDOC1000101823

Views: 20517

Downloads: 99

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next