No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Common Operation Guide

CloudEngine 12800, 12800E, 8800, 7800, 6800, and 5800 Series Switches

Rate and give feedback :
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Changing the User Level

Changing the User Level

User levels determine operation rights of users. There are 16 user levels, ranging from level 0 to 15. A larger value indicates a higher level. By default, the level of a user logging in through the console port is 15, and the level of a Telnet/STelnet user is 0.

User levels map command levels. A user can use only commands of the corresponding level or lower. Level-1 users can use only the commands at level 1 and level 0, and cannot use commands of higher levels.

To change the level of Level-3 or higher level users, run the following commands (VTY user interface is used as an example):
  • If password authentication is used, run:

    <HUAWEI> system-view
    [~HUAWEI] user-interface vty 0 4
    [~HUAWEI-ui-vty0-4] user privilege level 3   //Set the user level to 3.
    [*HUAWEI-ui-vty0-4] commit
    
  • If AAA authentication is used, run:

    <HUAWEI> system-view
    [~HUAWEI] aaa
    [~HUAWEI-aaa] local-user admin123 level 3   //Set the user level of admin123 to 3.
    [*HUAWEI-aaa] commit
    
NOTE:

Users cannot configure users with a higher level. For example, a Level-5 user can only configure users with level 1 to 5, and cannot configure users with a higher level.

If the user level configured on a user interface conflicts with that configured in the AAA view, the user level configured in the AAA view takes precedence.

Translation
Download
Updated: 2018-10-08

Document ID: EDOC1000102369

Views: 123028

Downloads: 3136

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next