Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document.
Note: Even the most advanced machine translation cannot match the quality of professional translators.
Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Common Interface Operations
- Splitting a 40GE Interface
- Switching an Interface to Layer 3 Mode
- Configuring an IP Address for the Management Interface
- Configuring an IP Address for a Layer 3 Sub-interface
- Configuring the Auto-Negotiation Mode on an Interface
- Configuring the Interface Rate
- Enabling Flow Control on an Interface
- Configuring the Interval for Collecting Traffic Statistics on an Interface
- How Do I View Information Such as Interface Status and Packet
Statistics?
- Clearing Traffic Statistics on an Interface
- Configuring the Delay in Reporting Interface Status Changes
- Configuring the Jumbo Frame Length
- Configuring a Port Group
- Configuring Layer 2 Port Isolation
- Configuring a Layer3 Sub-interface
- Disabling Link Flapping Protection on an Interface
- Configuring the MTU of an Interface
- Configuring the Training Function on an Interface
- Configuring Unidirectional Communication on an Interface
- Deleting the Configuration on a Specified Interface
- Configuring an Interface Down Event to Be Reported After a Delay
Previous
