No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Common Operation Guide

CloudEngine 12800, 12800E, 8800, 7800, 6800, and 5800 Series Switches

Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Configuring the Delay in Reporting Interface Status Changes

Configuring the Delay in Reporting Interface Status Changes

You can run the carrier {up-hold-time | down-hold-time} interval command in the interface view to configure the delay in reporting the interface status change. The system is unaware of the physical status changes on interfaces within the configured delay. If the interface physical status is not recovered after the delay expires, the physical status changes are reported to the system.

# Set the delay in reporting an interface Up event to 1000 milliseconds on 10GE1/0/1.

<HUAWEI> system-view
[~HUAWEI] interface 10ge 1/0/1
[~HUAWEI-10GE1/0/1] carrier up-hold-time 1000
[*HUAWEI-10GE1/0/1] commit
Translation
Download
Updated: 2018-10-08

Document ID: EDOC1000102369

Views: 196359

Downloads: 3214

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next