No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Common Operation Guide

CloudEngine 12800, 12800E, 8800, 7800, 6800, and 5800 Series Switches

Rate and give feedback :
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Setting the Number of Eth-Trunk Member Interfaces

Setting the Number of Eth-Trunk Member Interfaces

Except that each LAG on the CE5810EI supports a maximum of 8 member interfaces and that each LAG on the CE6880EI and CE12800E configured with ED-E, EG-E, or EGA-E series cards supports a maximum of 64 member interfaces, the maximum number of member interfaces on other models is configured using commands.

For the CE12800E configured with FD-X series cards and CE8800&7800&6800&5800:

Run the assign forward eth-trunk mode { 64 | 128 | 256 | 512 | 1024 } command in the system view to set the number of Eth-Trunk member interfaces supported by the switch. By default, a maximum of 128 interfaces can be aggregated on the switch.
  • When 64 is specified, the switch allows a maximum of 64 LAGs and each LAG supports a maximum of 32 member interfaces.
  • When 128 is specified, the switch allows a maximum of 128 LAGs and each LAG supports a maximum of 16 member interfaces.
  • When 256 is specified, the switch allows a maximum of 256 LAGs and each LAG supports a maximum of 8 member interfaces.
  • When 512 is specified, the switch allows a maximum of 512 LAGs and each LAG supports a maximum of 4 member interfaces.
  • When 1024 is specified, the switch allows a maximum of 1024 LAGs and each LAG supports a maximum of 2 member interfaces.

For the CE12800, CE6870EI, and CE6875EI:

Run the assign forward eth-trunk mode { 128 | 256 | 512 | 1024 } command in the system view to set the number of Eth-Trunk member interfaces supported by the switch. By default, a maximum of 512 interfaces can be aggregated on the switch.
  • When 128 is specified, the switch allows a maximum of 128 LAGs and each LAG supports a maximum of 128 member interfaces.
  • When 256 is specified, the switch allows a maximum of 256 LAGs and each LAG supports a maximum of 64 member interfaces.
  • When 512 is specified, the switch allows a maximum of 512 LAGs and each LAG supports a maximum of 32 member interfaces.
  • When 1024 is specified, the switch allows a maximum of 1024 LAGs and each LAG supports a maximum of 16 member interfaces.

Starting from V200R003C00, only the CE12800 supports 128.

NOTE:
After the assign forward eth-trunk mode command is used to change the number of Eth-Trunk member interfaces supported by the switch, restart the switch to make the configuration take effect.
Translation
Download
Updated: 2018-10-08

Document ID: EDOC1000102369

Views: 140473

Downloads: 3153

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next