No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search


To have a better experience, please upgrade your IE browser.


Common Operation Guide

CloudEngine 12800, 12800E, 8800, 7800, 6800, and 5800 Series Switches

Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Setting the LACP Priority

Setting the LACP Priority

LACP priorities include system and interface priorities.
  • The system priority determines the Actor and Partner. The device with a higher system priority is used as the Actor and the active interfaces are selected based on the Actor.

  • The interface priority determines selection of active interfaces. The interfaces with higher priority are selected as active interfaces.

The smaller the value, the higher the priority.
# Configure the LACP system priority.
<HUAWEI> system-view
[~HUAWEI] lacp priority 10
[*HUAWEI] commit
# Configure the LACP priority for 10GE1/0/1.
<HUAWEI> system-view
[~HUAWEI] interface eth-trunk 1
[*HUAWEI-Eth-Trunk1] trunkport 10ge 1/0/1
[*HUAWEI-Eth-Trunk1] mode lacp-static   //Before configuring the interface priority, ensure that the interface has been added to the Eth-Trunk in LACP mode.
[*HUAWEI-Eth-Trunk1] quit
[*HUAWEI] interface 10ge 1/0/1
[*HUAWEI-10GE1/0/1] lacp priority 1
[*HUAWEI-10GE1/0/1] commit
Updated: 2018-10-08

Document ID: EDOC1000102369

Views: 195224

Downloads: 3214

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Previous Next