No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search


To have a better experience, please upgrade your IE browser.


Common Operation Guide

CloudEngine 12800, 12800E, 8800, 7800, 6800, and 5800 Series Switches

Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Configuring an FC Interface

Configuring an FC Interface

Before configuring an FC interface, connect an FC optical module to the FC interface. If the LINK indicator is steady green, the FC interface is Up.

# Switch 10GE1/0/1 to an FC interface.

<HUAWEI> system-view
[HUAWEI] port mode fc 10ge 1/0/1
Warning: This operation will cause all the other configurations on the port to be lost. Continue? [Y/N]:y
[*HUAWEI] commit

# After the FC interface is configured, check the FC interface status. When the physical status and link protocol status of the FC interface are both Up, the interface works normally.

[~HUAWEI] display interface fc 1/0/1
FC1/0/1 current state : UP (ifindex: 144)
Line protocol current state : UP
Updated: 2018-10-08

Document ID: EDOC1000102369

Views: 196350

Downloads: 3214

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Previous Next