No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

OceanStor UltraPath for vSphere V100R008C50 User Guide 06

This document covers the functions, features, installation, configuration, upgrade, uninstallation, maintenance, troubleshooting, and FAQs of OceanStor UltraPath for vSphere (UltraPath forvSphere). UltraPath for vSphere is the multipathing software developed by HuaweiTechnologies Co., Ltd (Huawei for short). The document aims at helping users to be fully familiar with UltraPath for vSphere and its use.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Setting the Status of a Physical Path

Setting the Status of a Physical Path

Function

The set pathstate command is used to enable or disable a specified physical path.

Format

set pathstate -p path-id -s state

Parameters

Keyword and Parameter

Description

Default Value

-p path-id

ID of a physical path.

You can run show path without an ID to display all physical path IDs.

None

-s state

Enabling or disabling a physical path.

The value is either enable or disable.
  • enable: enables a physical path.
  • disable: disables a physical path.

None

Level

User root

Usage Guidelines

  • Once the command is run, UltraPath will not choose this path to deliver I/O.
  • Only T series V100R005 or later storage systems using Fibre Channel networks support this command.
  • If a controller module is disabled by running the set tpgstate command, you cannot run the set pathstate command to change the status of the controller's path.
  • When you replace an HBA, run the set pathstate -p path-id -s disable command to disable the designated physical path. UltraPath will switch I/Os smoothly to other physical paths.
  • When the HBA is replaced, run the set pathstate -p path-id -s enable command to enable the physical path mentioned earlier.

Example

Enable the physical path whose ID is 0.

~ # esxcli upadm set pathstate -p 0 -s enable
Succeeded in executing the command.

System Response

None

Translation
Download
Updated: 2019-03-06

Document ID: EDOC1000105152

Views: 36529

Downloads: 782

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next