No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

OceanStor UltraPath for vSphere V100R008C50 User Guide 06

This document covers the functions, features, installation, configuration, upgrade, uninstallation, maintenance, troubleshooting, and FAQs of OceanStor UltraPath for vSphere (UltraPath forvSphere). UltraPath for vSphere is the multipathing software developed by HuaweiTechnologies Co., Ltd (Huawei for short). The document aims at helping users to be fully familiar with UltraPath for vSphere and its use.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Setting the Switch of Host Alarm Push

Setting the Switch of Host Alarm Push

Function

set alarmenable is used to set the switch of host alarm push.

Format

set alarmenable -m mode

Parameters

Parameter

Description

Default Value

-m mode

Alarm push switch for UltraPath.

The value can be on or off, where:
  • on: Enables the alarm push switch.
  • off: Disables the alarm push switch.

on

Level

User root

Usage Guidelines

  • When the alarm push switch is enabled, UltraPath will detect the single-controller connectivity, link down, and link degrade, and send the link status to the storage system through alarms.

  • When the alarm push switch is disabled, the alarms reported by UltraPath to arrays cannot be cleared on the arrays. Therefore, disable the switch cautiously.

Example

Disable the alarm push switch for UltraPath:

~ # esxcli upadm set alarmenable -m off
Succeeded in executing the command. 
Please clear the alarm in the array manually, thanks.

System Response

None

Translation
Download
Updated: 2019-03-06

Document ID: EDOC1000105152

Views: 36495

Downloads: 782

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next