No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

OceanStor UltraPath for vSphere V100R008C50 User Guide 06

This document covers the functions, features, installation, configuration, upgrade, uninstallation, maintenance, troubleshooting, and FAQs of OceanStor UltraPath for vSphere (UltraPath forvSphere). UltraPath for vSphere is the multipathing software developed by HuaweiTechnologies Co., Ltd (Huawei for short). The document aims at helping users to be fully familiar with UltraPath for vSphere and its use.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Setting the Remote Controller of a VIS Storage System

Setting the Remote Controller of a VIS Storage System

Function

The set remotecontroller command is used to set the remote controller of a VIS storage system.

Format

set remotecontroller -a array-id -t tpg-id -s state

Parameters

Keyword and Parameter

Description

Default Value

-a array-id

ID of a storage system allocated by UltraPath for vSphere.

You can run show diskarray without an ID to display all storage system IDs.

None

-t tpg-id

ID of a controller.
NOTE:
You can specify multiple controllers at the same time.

None

-s state

Status of a remote controller.

The value can be local or remote.
  • local: local controller
  • remote: remote controller

remote

Level

User root

Usage Guidelines

NOTE:
UltraPath for vSphere supports remote active-active VIS storage systems. In this mode, the I/O processing latency on the local VIS node is much smaller than that on the remote one. Therefore, UltraPath for vSphere prefers the local VIS node for delivering I/Os. The remote VIS node is used only if the local node experiences a path fault.

Example

Set remote controller 0 of the storage system whose ID is 0 as a local node.

~ # esxcli upadm set remotecontroller -a 0 -t 0 -s local 
Succeeded in executing the command.

System Response

None

Translation
Download
Updated: 2019-03-06

Document ID: EDOC1000105152

Views: 36723

Downloads: 782

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next