No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search


To have a better experience, please upgrade your IE browser.


OceanStor UltraPath for vSphere V100R008C50 User Guide 06

This document covers the functions, features, installation, configuration, upgrade, uninstallation, maintenance, troubleshooting, and FAQs of OceanStor UltraPath for vSphere (UltraPath forvSphere). UltraPath for vSphere is the multipathing software developed by HuaweiTechnologies Co., Ltd (Huawei for short). The document aims at helping users to be fully familiar with UltraPath for vSphere and its use.

Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Resetting the Status of a Physical Path

Resetting the Status of a Physical Path


The set phypathnormal command is used to restore the working status of a degraded path to normal.


set phypathnormal -p path-id


Keyword and Parameter


Default Value

-p path-id

ID of the physical path.

You can run show phypath without an ID to display all physical path IDs.



User root

Usage Guidelines

You can perform the following operations to recover an unstable path degraded and isolated by UltraPath for vSphere if the maintenance personnel have replaced the fault components and eliminated link faults. After the path is recovered, UltraPath for vSphere will deliver I/Os to it. If you are not sure whether all link faults have been cleared, run the start pathcheck command to check the health status of the path. If the path passes the check, reset the path to normal.


Restore the working status of the path whose ID is 0 to normal.

~ # esxcli upadm set phypathnormal -p 0
Succeeded in executing the command.

System Response


Updated: 2019-03-06

Document ID: EDOC1000105152

Views: 41716

Downloads: 783

Average rating:
This Document Applies to these Products

Related Version

Related Documents

Previous Next