No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search


To have a better experience, please upgrade your IE browser.


OceanStor 2200 V3 and 2600 V3 Storage System V300R005 Command Reference 06

"Based on the CLI provided by the DeviceManager, this document describes how to use variouscommands classified by functions and how to set the CLI and manage the storage system throughthese commands."

Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
show lun_migration general

show lun_migration general


The show lun_migration general command is used to query the attributes of LUN migrations.


show lun_migration general [ source_lun_id=? ]





source_lun_id=? Source LUN ID.

Run the "show lun general" command without parameters to obtain the value.



Usage Guidelines

  • Run the "show lun_migration general" command to batch query migration attributes about all LUN migrations.
  • Run the "show lun_migration general source_lun_id=?" command to query attributes about a specific LUN migration.


  • To batch query the attributes of all LUN migrations, run the following command:

    admin:/>show lun_migration general
    Source LUN ID Source LUN Name Target LUN ID Target LUN Name Running Status Speed Process(%) Work Mode 
    ------------- --------------- ------------- --------------- -------------- ------ ---------- --------- 
    0 ff0000 10 ff0010 Migrated Middle -- Manual 
    1 ff0001 11 ff0011 Migrated Middle -- Manual 
    2 ff0002 12 ff0012 Migrated Middle -- Manual
  • To query the attributes of a specific LUN migration, run the following command:

    admin:/>show lun_migration general source_lun_id=0
    Source LUN ID : 0 
    Source LUN Name : ff0000 
    Target LUN ID : 10 
    Target LUN Name : ff0010 
    Running Status : Migrated 
    Speed : Low 
    Process(%) : -- 
    Start Time : 2014-11-16/13:19:56 UTC+08:00 
    End Time : 2014-11-16/13:22:26 UTC+08:00
    Work Mode : Manual

System Response

The following table describes the parameter meanings.



Source LUN ID

Indicates the source LUN ID.

Source LUN Name

Indicates the source LUN name.

Target LUN ID

Indicates the target LUN ID.

Target LUN Name

Indicates the target LUN name.

Running Status

Indicates the running status.


Indicates the speed.


Indicates the migration progress.

Start Time

Indicates the start time of the migration.

End Time

Indicates the end time of the migration.

Work Mode

Indicates the split mode.

Updated: 2019-07-22

Document ID: EDOC1000106139

Views: 364900

Downloads: 240

Average rating:
This Document Applies to these Products

Related Version

Related Documents

Previous Next