No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search


To have a better experience, please upgrade your IE browser.


OceanStor 2200 V3 and 2600 V3 Storage System V300R005 Command Reference 06

"Based on the CLI provided by the DeviceManager, this document describes how to use variouscommands classified by functions and how to set the CLI and manage the storage system throughthese commands."
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
delete failover_group general

delete failover_group general


The delete failover_group general command is used to delete a specified customized failover group.


delete failover_group general failover_group_id=?





failover_group_id=? ID of a failover group.
  • The value is an integer between 1 and 1024.
  • To obtain the value, run the "show failover_group general" command without parameters.



Usage Guidelines

  • Run the "show failover_group general" command to view the failover group ID.
  • Run the "delete failover_group failover_group_id=?" command to delete a specified customized failover group. Only customized failover groups are supported.
  • OceanStor 2200 V3 storage system do not support this command.


Delete a specified customized failover group.

admin:/>delete failover_group general failover_group_id=1
DANGER: You are about to delete a customized failover group. After this operation, logical ports that are originally associated with the failover group will be associated with the default failover group or VLAN failover group. Then, these logical ports may fail over to wrong ports, causing service interruption.
Suggestion: Before performing this operation, ensure that the failover of the logical ports that are originally associated with the failover group will not affect service operation.
Have you read danger alert message carefully?(y/n)y
Are you sure you really want to perform the operation?(y/n)y
Command executed successfully.

System Response


Updated: 2019-07-22

Document ID: EDOC1000106139

Views: 317467

Downloads: 210

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Previous Next