No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search


To have a better experience, please upgrade your IE browser.


OceanStor 2200 V3 and 2600 V3 Storage System V300R005 Command Reference 06

"Based on the CLI provided by the DeviceManager, this document describes how to use variouscommands classified by functions and how to set the CLI and manage the storage system throughthese commands."

Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Command Line Completion

Command Line Completion

On the command line interface (CLI), you can either press the Tab or space key to complete a command line in stages.

Though both keys can be used to complete the operating segment of a command line, they imply a difference. Pressing the Tab key completes the operating segment while displaying all the possible values for the segment, whereas pressing the space key simply completes the operating segment. The following example is based on using the Tab key.
  • Press Tab once to display the available starting segments of a command line.
    admin:/>//Press Tab.
    add                 change              create              
    delete              exit                export              
    help                import              poweroff            
    poweron             reboot              remove              
    scan                show                swap 
  • After the starting segment is determined and completed, press Tab once to display the available adjacent segments of the starting segment.
    admin:/>add//Press Tab.
    cache_partition      clone                consistency_group    
    disk_domain          host                 host_group           
    lun_copy             lun_group            mapping_view         
    notification         port                 port_group           
    remote_device        security_rule        smartqos_policy      
    snmp                 storage_pool   
  • When part of a segment has been typed and its intact form can be determined by the CLI, pressing Tab once completes the segment while displaying available adjacent segments.
    admin:/>add po//Press Tab.
    admin:/>add port
    port               port_group
  • When an intact command line has been typed, pressing Tab responds you with a message stating that the command line can be executed. In this condition, pressing Enter executes the command line.
    admin:/>add port ipv4_route eth_port_id=0 type=net target_ip= mask= gateway= Tab.
    Command is executable now.
Updated: 2019-07-22

Document ID: EDOC1000106139

Views: 365312

Downloads: 240

Average rating:
This Document Applies to these Products

Related Version

Related Documents

Previous Next