No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search


To have a better experience, please upgrade your IE browser.


OceanStor 2200 V3 and 2600 V3 Storage System V300R005 Command Reference 06

"Based on the CLI provided by the DeviceManager, this document describes how to use variouscommands classified by functions and how to set the CLI and manage the storage system throughthese commands."
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
add consistency_group remote_replication_delay

add consistency_group remote_replication_delay


The add consistency_group remote_replication_delay command is used to add a remote replication into a consistency group after the initial synchronization of the remote replication is complete.


add consistency_group remote_replication_delay consistency_group_id=? remote_replication_id=?





consistency_group_id=? ID of a consistency group.

To obtain the value, run "show consistency_group general".

remote_replication_id=? ID of the remote replication that you want to add to a consistency group.

To obtain the value, run "show remote_replication general".



Usage Guidelines

  • This command can be used when: the initial synchronization of an asynchronous consistency group is complete; the asynchronous consistency group is in the cycle mode; and you do not want to affect the RPO of the asynchronous consistency group after adding the remote replication that is in initial synchronization into the asynchronous consistency group.
  • This is an asynchronous command. After you execute this command, operations, such as splitting the remote replication, consistency group, adding the remote replication to the consistency group, and restarting the synchronization of the consistency group, are performed on the background.
  • This command can only be performed when the consistency group having at least one member is in the synchronization or normal state, and the remote replication is in the initial synchronization.
  • After you perform this operation, do not operate the remote replication and consistency group again to prevent operation failures.


Add the remote replication whose ID is "9747215445131234" to consistency group "9747215445131264" in delayed mode.

admin:/>add consistency_group remote_replication_delay consistency_group_id=9747215445131264 remote_replication_id=9747215445131234
CAUTION: You are about to add a remote replication to a consistency group in delayed mode. Before performing this operation, note that:
1. This operation is an asynchronous operation, and will be executed after the initial synchronization of the remote replication is complete. 
2. Before adding a remote replication to a consistency group, do not operate the remote replication and consistency group. Otherwise, this operation may fail, and the remote replication and consistency group will be in split state. 
Suggestion: Perform this operation based on customer requirements.
Do you wish to continue?(y/n)y
Command executed successfully.

System Response


Updated: 2019-07-22

Document ID: EDOC1000106139

Views: 316009

Downloads: 206

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Previous Next