No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

OceanStor 2200 V3 and 2600 V3 Storage System V300R005 Command Reference 06

"Based on the CLI provided by the DeviceManager, this document describes how to use variouscommands classified by functions and how to set the CLI and manage the storage system throughthese commands."
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
create lun_migration

create lun_migration

Function

The create lun_migration command is used to create a LUN migration.

Format

create lun_migration source_lun_id=? target_lun_id=? [ speed=? ] [ work_mode=? ]

Parameters

Parameter

Description

Value

source_lun_id=? ID of a source LUN.

Run the "show lun general" command without parameters to obtain the value.

target_lun_id=? ID of a target LUN.

Run the "show lun general" command without parameters to obtain the value.

speed=? Data migration speed of a LUN.

The value can be Low, Middle, High, Highest, and the default value is Middle.

work_mode=? Split mode of a LUN migration.

The value can be Auto, Manual, and the default value is Auto.

Level

Administrator

Usage Guidelines

None

Example

To create LUN migration, run the following command:

admin:/>create lun_migration source_lun_id=5 target_lun_id=7 
WARNING: You are about to create a migration relationship between source LUN and target LUN. Migration starts immediately after the relationship is established, and the data on the target LUN will be overwritten by that on the source LUN after the migration.
Suggestion: Before performing this operation, ensure that the selected source LUN and target LUN are correct and the target LUN is not being read or written by hosts.If the capacity of the target LUN is larger than that of the source LUN, scan for the source LUN again after the migration is complete.
Have you read warning message carefully?(y/n)Y
Are you sure you really want to perform the operation?(y/n)Y
Command executed successfully.

System Response

None

Translation
Download
Updated: 2019-07-22

Document ID: EDOC1000106139

Views: 318430

Downloads: 210

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next