No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search


To have a better experience, please upgrade your IE browser.


OceanStor 2200 V3 and 2600 V3 Storage System V300R005 Command Reference 06

"Based on the CLI provided by the DeviceManager, this document describes how to use variouscommands classified by functions and how to set the CLI and manage the storage system throughthese commands."
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
remove port ipv6_route

remove port ipv6_route


The remove port ipv6_route command is used to remove an IPv6 route configured for a specific iSCSI host port.


remove port ipv6_route eth_port_id=? target_ip=?





eth_port_id=? ID of a port.

To obtain the value, run "show port general". The value contains 1

to 31 characters, including letters, digits, and periods (.). The value cannot

start with a digit or a period (.), or end with a period (.).

target_ip=? Address of the IPv6 network segment where a host resides.

The value must be an IPv6 address.



Usage Guidelines

Before running this command, please guarantee that the port had the IPv6 route.


To remove an IPv6 route configured for the iSCSI host port whose ID is "ENG0.A3.P0", where the target network segment address is "1118::0", run the following command. The ID and output vary depending on a specific product.

admin:/>remove port ipv6_route eth_port_id=ENG0.A3.P0 target_ip=1118::0
DANGER: You are going to remove the route of iSCSI host port.
This operation will interrupt the connection between the storage system and host.
Suggestion: Before you perform this operation, ensure that you have stopped the business on the route.
Have you read danger alert message carefully?(y/n)y
Are you sure you really want to perform the operation?(y/n)
Command executed successfully.

System Response


Updated: 2019-07-22

Document ID: EDOC1000106139

Views: 315040

Downloads: 204

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Previous Next