No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search


To have a better experience, please upgrade your IE browser.


OceanStor 2200 V3 and 2600 V3 Storage System V300R005 Command Reference 06

"Based on the CLI provided by the DeviceManager, this document describes how to use variouscommands classified by functions and how to set the CLI and manage the storage system throughthese commands."
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
add remote_device link iscsi

add remote_device link iscsi


The add remote_device link iscsi command is used to add Internet Small Computer System Interface (iSCSI) links. Run this command to connect the storage system to a remote device through iSCSI links.


add remote_device link iscsi remote_device_id=? local_controller=? local_port_id=? ip=? [ recovery_policy=? ]





remote_device_id=? ID of a remote device.

To obtain the value, run "show remote_device general".

local_controller=? ID of a local controller to which a link routes.

The value is in the format of "XA", "XB", "XC" or "XD", where the "X" is an integer such as 0, 1.

local_port_id=? ID of an iSCSI host port.

To obtain the value, run "show port general".The value contains 1 to 31 characters, including letters, digits, and periods (.). The value cannot start with a digit or a period (.), or end with a period (.).

ip=? IP address of a remote device.


recovery_policy=? A link recovery policy.

The value can be:

  • "automatic": indicates automatic recovery.
  • "manual": indicates manual recovery.
The default value is "automatic".



Usage Guidelines



To add an iSCSI link for remote device "0", where the local controller is controller "0A", the ID of the employed port is "ENG0.A4.P0", and the IP address of the remote device is "", run the following command. The ID and output vary depending on a specific product.

admin:/>add remote_device link iscsi remote_device_id=0 local_controller=0A local_port_id=ENG0.A4.P0 ip=
Command executed successfully.

System Response


Updated: 2019-07-22

Document ID: EDOC1000106139

Views: 319431

Downloads: 210

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Previous Next