No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search


To have a better experience, please upgrade your IE browser.


OceanStor 2200 V3 and 2600 V3 Storage System V300R005 Command Reference 06

"Based on the CLI provided by the DeviceManager, this document describes how to use variouscommands classified by functions and how to set the CLI and manage the storage system throughthese commands."

Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
change alarm_mask

change alarm_mask


The change alarm_mask command is used to mask specified alarms.


change alarm_mask alarm_id_list=? mask_switch=?





alarm_id_list=? List of IDs of masked alarms.
  • Alarms saved in the configuration file.
  • Multiple IDs are separated by commas (,).
mask_switch=? Switch of the alarm masking function.

The value can be "on" or "off", where:

  • "on": The alarm masking function is enabled.
  • "off": The alarm masking function is disabled.



Usage Guidelines

  • An alarm ID is a hexadecimal number. Separate alarm IDs in the ID list from each other with commas (,). A maximum of 64 alarm IDs are supported.
  • When the alarm masking function is enabled, masked alarms are neither reported to the network management system nor sent by email, short message, or syslog.
The alarm masking function does not affect email test alarms and short message test alarms.


Mask two specified alarms.

admin:/>change alarm_mask alarm_id_list=0x100F00A000F,0x100F0C90066 mask_switch=on
WARNING: You are about to enable the alarm masking function. This operation will make the masked alarms are neither reported to the DeviceManager nor sent by email, short message, or syslog. But the alarm masking function does not affect email test alarms and short message test alarms.
Suggestion: Before performing this operation, ensure that the alarms need to be masked.
Have you read warning message carefully?(y/n)y
Are you sure you really want to perform the operation?(y/n)y
Change alarm 0x100F00A000F mask switch successfully.
Change alarm 0x100F0C90066 mask switch successfully.

System Response


Updated: 2019-07-22

Document ID: EDOC1000106139

Views: 369680

Downloads: 245

Average rating:
This Document Applies to these Products

Related Version

Related Documents

Previous Next