No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search


To have a better experience, please upgrade your IE browser.


OceanStor 2200 V3 and 2600 V3 Storage System V300R005 Command Reference 06

"Based on the CLI provided by the DeviceManager, this document describes how to use variouscommands classified by functions and how to set the CLI and manage the storage system throughthese commands."

Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
change hyper_metro_pair priority

change hyper_metro_pair priority


The change hyper_metro_pair priority command is used to change the priority of the primary and secondary LUNs of a SAN HyperMetro pair.


change hyper_metro_pair priority pair_id=?





pair_id=? ID of the HyperMetro pair.

Run the "show hyper_metro_pair general" command without parameters to obtain the value.



Usage Guidelines

OceanStor 2200 V3 storage system do not support this command.


To change the priority of the primary and secondary LUNs of HyperMetro pair "1", run the following command.

admin:/>change hyper_metro_pair priority pair_id=1
CAUTION: You are about to perform a preferred/non-preferred site switchover. This operation will modify the arbitration priority of member LUNs in a HyperMetro pair when the communication between two storage arrays is interrupted.
In static priority arbitration mode, if the communication between two storage arrays is interrupted upon a priority switchover, storage array arbitration fails at the two sites.
Suggestion: In static priority arbitration mode, before performing this operation, suspend the HyperMetro pair.
Do you wish to continue?(y/n)y
Command executed successfully.

System Response


Updated: 2019-07-22

Document ID: EDOC1000106139

Views: 363132

Downloads: 235

Average rating:
This Document Applies to these Products

Related Version

Related Documents

Previous Next