No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search


To have a better experience, please upgrade your IE browser.


OceanStor 2200 V3 and 2600 V3 Storage System V300R005 Command Reference 06

"Based on the CLI provided by the DeviceManager, this document describes how to use variouscommands classified by functions and how to set the CLI and manage the storage system throughthese commands."

Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
show remote_device general

show remote_device general


The show remote_device general command is used to query information on remote devices.


show remote_device general [ scope=? ] [ remote_device_id=? ] [ array_type=? ]





remote_device_id=? ID of a remote device.

To obtain the value, run "show remote device general" without parameters.

scope=? Scope of a query.

The value can be:

  • "linked_array": The remote devices that have been connected to the storage system will be queried for.
  • "all": Any created remote devices will be queried for no matter those devices have connected to the storage system or not.
array_type=? Type of a remote device.

The value can be:

  • replication:The remote device is made by Huawei.
  • heterogeneity:The remote device is made by a third-party manufacturer.



Usage Guidelines

  • The following parameters or parameter sets are mutually exclusive: scope, remote_device_id, and array_type.2:Run the show remote_device general command to query the information about all remote devices.3:Run the show remote_device general remote_device_id= command to query the information about a specified remote device.4:Run the show remote_device general scope= command to query the information about remote devices in a specified scope.5:Run the show remote_device general array_tppe= command to query the information about remote devices with a specified type.


To query details on existing remote devices, run the following command:

admin:/>show remote_device general
ID Name Health Status Running Status WWN SN Device Type Remote Device Type
--- -------------- ------------- -------------- --- -- ------------------------- ------------------
512 Default Device Normal Link Up -- -- Heterogeneity --

System Response

The following table describes the parameter meanings.




ID of remote device.


Name of remote device.

Health Status

Health State of remote device.

Running Status

Running state of remote device.


World wild name of remote device.


Serial number of remote device.

Device Type

Type of remote device.

Remote Device Type

Product ID of remote device.

Updated: 2019-07-22

Document ID: EDOC1000106139

Views: 364351

Downloads: 238

Average rating:
This Document Applies to these Products

Related Version

Related Documents

Previous Next