No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search


To have a better experience, please upgrade your IE browser.


OceanStor 2200 V3 and 2600 V3 Storage System V300R005 Command Reference 06

"Based on the CLI provided by the DeviceManager, this document describes how to use variouscommands classified by functions and how to set the CLI and manage the storage system throughthese commands."
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
change service ndmp_config

change service ndmp_config


The change service ndmp_config command is used to change NDMP configuration.


change service ndmp_config { is_enabled=? | port=? | ip=? | restore_quota=? | support_snapshot=? | ignore_ctime=? } *





is_enabled=? Whether enable the NDMP service.

The value is yes or no.

  • yes:Enable NDMP service.
  • no:Disable NDMP service.
port=? Listening port for NDMP.

The value ranges from 10000 to 10099.

ip=? Listening IP for NDMP.


restore_quota=? The quota of restoring to file system.

The value ranges from 0 to 100.

support_snapshot=? Parameter used to decide whether to support snapshot on file system. This command can only be executed in developer mode. For details about how to log in to developer mode, see Restricted Command Reference.

The value is yes or no.

  • yes:Support snapshot.
  • no:Not support snapshot.
ignore_ctime=? Whether ignore the ctime for backup.

the value is yes or no.

  • yes:Ignore ctime.
  • no:Consider ctime.



Usage Guidelines

1.At least one parameter must be specified.

2.The "is_enabled" parameter is used to start the NDMP service and is mutually exclusive with all other parameters.

3.This command does not support OceanStor 2200 V3 storage system.


  • To change NDMP configuration, run the following command.

    admin:/>change service ndmp_config port=10000 ip= restore_quota=95 ignore_ctime=no
    Command executed successfully.
  • To change NDMP configuration, run the following command.

    admin:/>change service ndmp_config is_enabled=yes
    Command executed successfully.
  • To close NDMP configurations, run the following command.

    admin:/>change service ndmp_config is_enabled=no
    WARNING:You are about to disable the NDMP service. This operation causes the NDMP service provided by the storage device unavailable. 
    Suggestion: Before performing this operation, ensure that the NDMP service is no longer needed.
    Have you read warning message carefully?(y/n)y
    Are you sure you really want to perform the operation?(y/n)y
    Command executed successfully

System Response


Updated: 2019-07-22

Document ID: EDOC1000106139

Views: 319756

Downloads: 210

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Previous Next