No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

OceanStor 2200 V3 and 2600 V3 Storage System V300R005 Command Reference

"Based on the CLI provided by the DeviceManager, this document describes how to use variouscommands classified by functions and how to set the CLI and manage the storage system throughthese commands."
Rate and give feedback :
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
change remote_replication split

change remote_replication split

Function

The change remote_replication split command is used to split a remote replication task. During the split of a remote replication task, the primary resource synchronizes with secondary resources for the last time, then data synchronization stops between both resources.

Format

change remote_replication split remote_replication_id=?

Parameters

Parameter

Description

Value

remote_replication_id=? ID of a remote replication task.

To obtain the value, run "show remote_replication unified".

Level

Administrator

Usage Guidelines

  • Before running this command, ensure that the selected remote replication task is exactly the one you want to split.
  • You cannot split a remote replication task that has been added to a consistency group. In this condition, you must remove the remote replication task from the consistency group before you can split the task.
  • Exercise caution when you attempt to split an asynchronous remote replication task whose primary and secondary resources are in the "initial synchronization" state or to split a synchronous remote replication task whose replication pair state is "synchronizing", because both attempts may cause data loss on employed secondary resources.
  • After you split the primary and secondary resources for a remote replication task, the data of the secondary resources will be consistent with that of the primary resource when it was split. A secondary resource is available to serve as a backup of the primary resouce only when the status of the secondary resource is "consistent" or "synchronized".

Example

To split remote replication task "9747215445131264", run the following command:

admin:/>change remote_replication split remote_replication_id=9747215445131264
DANGER: You are about to split the primary resource from the secondary resource in remote replication. This operation causes the data on the secondary resource to become inconsistent with the data on the primary resource.
Suggestion: Before you perform this operation, determine whether the split is necessary.
Have you read danger alert message carefully?(y/n)y
 
Are you sure you really want to perform the operation?(y/n)y
Command executed successfully.

System Response

None

Translation
Download
Updated: 2019-04-22

Document ID: EDOC1000106139

Views: 259903

Downloads: 176

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next