No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

OceanStor 2200 V3 and 2600 V3 Storage System V300R005 Command Reference

"Based on the CLI provided by the DeviceManager, this document describes how to use variouscommands classified by functions and how to set the CLI and manage the storage system throughthese commands."
Rate and give feedback :
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
change system management_ip

change system management_ip

Function

The change system management_ip command is used to configure the IP address of a management port on new hardware. Both an IPv4 and IPv6 address can be configured, which is used by terminals to access the disk array.

Format

change system management_ip eth_port_id=? ip_type=? [ ipv4_address=? mask=? gateway_ipv4=? ] [ ipv6_address=? prefix_length=? gateway_ipv6=? ]

Parameters

Parameter

Description

Value

eth_port_id Indicates the port ID.

To obtain the value, run "show system management_ip". The value contains 1 to 31 characters, including letters, digits, and periods (.). The value cannot start with a digit or a period (.), or end with a period (.).

ip_type Indicates the IP address type.

The value can be an IPv4 or IPv6 address.

ipv4_address Indicates the IPv4 address.

IPv4 address can not begin with 0.

mask Indicates the IPv4 subnet mask of the management port.

-

gateway_ipv4 Indicates the configured IPv4 gateway.

-

ipv6_address Indicates the configured IPv6 address of the management port.

-

prefix_length Indicates the configured IPv6 subnet mask.

-

gateway_ipv6 Indicates the configured IPv6 gateway of the management port.

The value must be an IPv6 address.

Level

Administrator

Usage Guidelines

  • When the maintenance terminal and the storage system are not in the same network segment, the terminal cannot access the storage system. You have to add a router to the maintenance terminal and a gateway to the storage system so that the maintenance terminal can access the storage system.
  • Before performing the operation, ensure that the address you entered is valid and the IPv4 address must not start with 0.
  • Changing the IP address of the management port may disconnect a user that has logged in from the storage system, so log in to the storage system again after changing the IP address.
  • The maintenance terminal can access the storage system both through an IPv4 and IPv6 address.

Example

Set the IPv4 address of a specified management network port to 192.168.190.2, the subnet mask to 255.255.0.0, and the gateway address to 192.168.0.1, run the following command. The command output varies depending on a specific product.

admin:/>change system management_ip eth_port_id=ENG0.MGMT0.0 ip_type=ipv4_address ipv4_address=192.168.190.2 mask=255.255.0.0 gateway_ipv4=192.168.0.1
WARNING: You are going to modify the network address of network port. If you enter an unavailable network address, the O&M interface of the storage system is inaccessible.
Suggestion: Before you perform this operation, ensure that you have entered an available network address.
Have you read warning message carefully?(y/n)

System Response

None

Translation
Download
Updated: 2019-04-22

Document ID: EDOC1000106139

Views: 264806

Downloads: 178

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next