No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search


To have a better experience, please upgrade your IE browser.


OceanStor 2200 V3 and 2600 V3 Storage System V300R005 Command Reference 06

"Based on the CLI provided by the DeviceManager, this document describes how to use variouscommands classified by functions and how to set the CLI and manage the storage system throughthese commands."
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
change storage_pool relocation_schedule

change storage_pool relocation_schedule


change storage_pool relocation_schedule command is used to change the relocation policy for a storage pool.


change storage_pool relocation_schedule pool_id=? relocation_type=?

change storage_pool relocation_schedule pool_id=? relocation_action=? [ duration=? ]





pool_id=? Storage pool ID.

The value is an integer ranging from 0 to 511.

To obtain the value, run "show storage_pool general".

relocation_type=? Data migration triggering mode. If you specify this parameter, you cannot specify parameter relocation_action=?.

The value can be "automatic" or "manual", where:

  • "automatic": indicates timed migration.
  • "manual": indicates manual migration.
relocation_action=? Data migration action. If you specify this parameter, you cannot specify parameter relocation_type=?.

The value can be "start", "stop", "pause", or "continue", where:

  • "start": starts data migration.
  • "stop": stops data migration.
  • "pause": suspends data migration.
  • "continue": continues data migration.
duration=? Duration of data migration. This parameter must be specified when relocation_action=? is set to "start".

The value is in the format of HH:MM or H:M. The value ranges from 00:30 to 24:00, indicating 30 minutes to 24 hours.



Usage Guidelines



Change the data migration triggering mode of storage pool "0" to "automatic".

admin:/>change storage_pool relocation_schedule pool_id=0 relocation_type=automatic
Command executed successfully.

System Response


Updated: 2019-07-22

Document ID: EDOC1000106139

Views: 317095

Downloads: 210

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Previous Next