No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search


To have a better experience, please upgrade your IE browser.


OceanStor 2200 V3 and 2600 V3 Storage System V300R005 Command Reference 06

"Based on the CLI provided by the DeviceManager, this document describes how to use variouscommands classified by functions and how to set the CLI and manage the storage system throughthese commands."
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
create vlan general

create vlan general


The create vlan general command is used to create a VLAN.


create vlan general vlan_id=? port_type=? [ eth_port_id=? ] [ bond_port_id=? ]





vlan_id=? VLAN ID (tag value).

The value is an integer between "1" and "4094".

port_type=? VLAN type.

There are two types of values:

  • eth: physical port
  • bond: bond port.
eth_port_id=? ID of an physical port.

To obtain the value, run the "show port general" command. The value contains 1

to 31 characters, including letters, digits, and periods (.). The value cannot

start with a digit or a period (.), or end with a period (.).

bond_port_id=? ID of a bond port.

To obtain the value, run the "show bond_port" command. The value contains 1

to 63 characters comprised of digits.



Usage Guidelines

  • When "port_type" is set to "eth", "eth_port_id" must be specified.
  • When "port_type" is set to "bond", "bond_port_id" must be specified.
  • OceanStor 2200 V3 storage system do not support this command.


  • To create a VLAN whose ID is "1", port type is "eth", and port ID is "ENG0.A2P1", run the following command:

    admin:/>create vlan general vlan_id=1 port_type=eth eth_port_id=ENG0.A2.P1
    Command executed successfully.
  • To check the VLAN you have created, run the following command:

    admin:/>show vlan general
    Name Running Status VLAN ID MTU Port Type Port ID 
    ---------- ----------- ------- ---- ---------- ----------
    ENG0.A2.P0.2 Link Down 2 1500 ETH ENG0.A2.P0 
    ENG0.A2.P1.1 Link Down 1 1500 ETH ENG0.A2.P1

System Response


Updated: 2019-07-22

Document ID: EDOC1000106139

Views: 319737

Downloads: 210

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Previous Next