No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search


To have a better experience, please upgrade your IE browser.


OceanStor 2200 V3 and 2600 V3 Storage System V300R005 Command Reference 06

"Based on the CLI provided by the DeviceManager, this document describes how to use variouscommands classified by functions and how to set the CLI and manage the storage system throughthese commands."

Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
change hyper_metro_consistency_group synchronize

change hyper_metro_consistency_group synchronize


The change hyper_metro_consistency_group synchronize command is used to start the synchronization of a HyperMetro consistency group.


change hyper_metro_consistency_group synchronize consistency_group_id=?





consistency_group_id=? ID of the HyperMetro consistency group.

Run the "show hyper_metro_consistency_group general" command without parameters to obtain the value.



Usage Guidelines

OceanStor 2200 V3 storage system do not support this command.


To start the synchronization of HyperMetro consistency 1, run the following command.

admin:/>change hyper_metro_consistency_group synchronize consistency_group_id=1
WARNING: You are about to start data synchronization. 
Once data synchronization is started, the system will synchronize data based on the synchronization direction of the consistency group and the data at the synchronized end cannot be restored. 
Suggestion: Before performing this operation, ensure that the parameters are correct to prevent data loss.
Have you read warning message carefully?(y/n)y
Are you sure you really want to perform the operation?(y/n)y
Command executed successfully.

System Response


Updated: 2019-07-22

Document ID: EDOC1000106139

Views: 364947

Downloads: 240

Average rating:
This Document Applies to these Products

Related Version

Related Documents

Previous Next