No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search


To have a better experience, please upgrade your IE browser.


OceanStor 2200 V3 and 2600 V3 Storage System V300R005 Command Reference 06

"Based on the CLI provided by the DeviceManager, this document describes how to use variouscommands classified by functions and how to set the CLI and manage the storage system throughthese commands."

Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
add logical_port ipv4_route

add logical_port ipv4_route


The add logical_port ipv4_route command is uesed to add the logical port IPv4 route.


add logical_port ipv4_route logical_port_name=? type=? [ ipv4_address=? ] [ ipv4_mask=? ] ipv4_gateway=? [ table_type=? ]





logical_port_name=? Logical port name.

To obtain the value, run "show logic_port general".

type=? Logical port route type.

The value can be "net", "host", or "default", where:

  • "net": indicates a route to the target network segment.
  • "host": indicates a route to the target host.
  • "default": indicates a default route. If there is no route to the target network segment or the target host, the target host accesses the storage system through the default route.
ipv4_address=? Logical port IPv4 address.

The IPv4 address can not be started with 0.

ipv4_mask=? Logical port IPv4 mask.


ipv4_gateway=? Logical port IPv4 gateway.


table_type=? Logical port route table type.

The value can be "all", "policy_table", or "default_table", where:

  • "all": indicates a policy and default route table.
  • "policy_table": indicates a policy route table.
  • "default_table": indicates a default route table.



Usage Guidelines

  • When the value of type is net or host, the parameter ipv4_address is expected.
  • When the value of type is net, the parameter ipv4_mask is expected.
  • OceanStor 2200 V3 storage system do not support this command.


Add IPv4 route for logical port.

admin:/>add logical_port ipv4_route logical_port_name=lif1 type=net ipv4_address= ipv4_mask= ipv4_gateway= table_type=all
Command executed successfully.

System Response


Updated: 2019-07-22

Document ID: EDOC1000106139

Views: 364605

Downloads: 238

Average rating:
This Document Applies to these Products

Related Version

Related Documents

Previous Next