No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

OceanStor 2200 V3 and 2600 V3 Storage System V300R005 SmartVirtualization Feature Guide 07

Rate and give feedback :
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Fujitsu E4000 Model 80/100

Fujitsu E4000 Model 80/100

This section describes the precautions about configuration operations performed on the Fujitsu E4000 Model 80/100 whose LUNs are hosted by the OceanStor 2200 V3/2600 V3.

  • For a standard direct-connection network, set FC Connection Settings to FC-AL Connection; For a standard switched network, set FC Connection Settings to Fabric Connection.
  • Configure port parameters based on the values in the following figure.

    Service Class

    Class 3

    FC Transfer Rate

    4G/2G/1G Bit Auto Setting

    Scope of LUR Action

    Acts on T_L

    HP-UX Connection Setting

    Disable

    Addressing Mode Settins

    Host Table Settings Mode

    NOTE:

    In the preceding figure, the Frame Size Setting and Release Reservation upon Chip Reset configuration has no restrictions.

  • Configure host parameters based on the values in the following figure.

    Response status to host when overloaded

    Unit Attention (Delay)

    Response to inquiry commands

    Default

    Inquiry Standard Data NACA Function

    Disable

    Inquiry Standard Data Version Field

    Default

    Inquiry Command Page 83

    Type 01 & 03

    Target Port Group Access Support

    Enable

    Response Sense at Firmware Hot Switching

    Enable

    NOTE:

    In the preceding figure, the Reservation Conflict Response to Test Unit Ready Commands configuration has no restrictions.

NOTE:

For details about how to set parameters that are not mentioned in this section, see the related documents of the Fujitsu E4000 Model 80/100.

Translation
Download
Updated: 2018-12-29

Document ID: EDOC1000106155

Views: 56994

Downloads: 143

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next